Coatings World - September 2012

pared steel, aluminum, fiber glass, rigid plastics and plastic fillers. The DPLV Epoxy Primer can also be used as a sealer and topcoated with many of PPG’s two-component urethane undercoats and topcoats. It is compatible with waterborne basecoats as well. DPLV 2.1 Epoxy Primer is available in three colors: White DP48LV, Gray DP50LV and Black DP90LV. These can be blended to achieve a broad range of gray shades.

Master Bond introduces epoxy-based UV curable UV15 for bonding and sealing applications

With its light transmission properties and optical clarity, Master Bond UV15 is widely used for a variety of bonding, coating and sealing applications in the optical, electronic and optoelectronic industries. This epox- based UV curable system is 100 percent reactive and does not contain any solvents or other volatiles. It is also completely free of any oxygen inhibition.

Like most UV systems, Master Bond
UV15 will cure quickly and easily when
exposed to a UV light source with a wave-
length range between 320-365 nm. It typ-
ically cures in thicknesses of a few mi-
crons to 0.015-0.020 inches in 15-30 sec-
onds or less. UV15 cures by a cationic
reaction and produces bonds that have
lower shrinkage (1-2%) and higher tem-
perature resistance than most UV systems.
Its glass transition temperature (Tg) is 90-
95°C with a straight UV cure. When post
cured for 30 minutes at 125°C, the Tg is
125-130°C. The service temperature range
for this system is - 80°F to +350°F.

Mereco introduces Metaduct 1245, an epoxy electrically conductive ultra-fast curing adhesive Mereco has unveiled a new, ultra-fast curing silver adhesive which is electrically conductive for cold soldering and bonding electrical and electronic components where soldering is impractical. Mereco Metaduct 1245 is a fast curing rapid bonding room temperature setting epoxy electrically conductive adhesive. After only 45 seconds Mereco said MetaductTM 1245 provides tensile shear strengths in excess of 600 psi. This unique non-flam-mable one hundred percent solid adhesive has a 2:1 mix ratio by weight or by volume and sets to a highly electrically conductive bond. Mereco Metaduct 1245 repairs printed circuits, fastens down and seals electronic components, can replace soft soldering and welding of jewelry which can be electrically plated. It is used for bonding electrical and electronic devices where soldering is not practical and electrical conductivity is a requirement.

Benjamim Moore Adds Molten Metallics To Its
Studio Finishes Collection

Benjamin Moore has introduced Molten Metallics, a new addition to its Studio Finishes portfolio. The name of this new paint product evokes the end result: a surface imitative of a hand-hammered metal.

While most of the special effects coatings in the Studio Finishes collection are glazes, Molten Metallics is an alkyd high gloss paint. It is ideal for adding a dramatic, glamorous look to furniture, decorative pieces, trim and accent ceilings and walls. It also is recommended for exterior surfaces and delivers an effective rust-resistant treatment.

“The illusion of the texture that Molten Metallics creates is
captivating and sensual,” said Sonu Mathew, Benjamin
Moore’s senior interior designer. “It’s an easy way to produce
a rarified look that only artisans typically have mastered. And,
it’s a lot more economical, too.”
Six standard ready-mixed colors are offered: Gold, Copper,
Bronze, Gun Smoke, Silver and Charcoal.